When it comes to household woodworkings, the most famous choice is a random orbital sander. It is so because of its easy grip and the random motions that leave minimal to no scratch marks. Even though it is a power tool, the overall design is simple and the sandpaper disc gets work done fast giving a smooth result which one should learn from random orbital sander reviews.
But when one, who is not much of a professional, works with such tools there is always a chance of making mistakes or messing up the DIY project. Below some of the mistakes are mentioned that one can try to avoid while working with a random orbital sander:
Putting extra pressure
When working with this electronic sander, avoid putting extra pressure on the tool when it is in motion, not even a little bit. The extra pressure can cause harm to the motor and may also slow down the entire sanding process. So instead of harming the work quality let the sandpaper disk do its job.
Do not skip on grits
There a wide variety of sandpaper grits available and every one of them is required. So avoid skipping grits because each of them is required to get that nice wood finishing. The grits range from 80 to 320, but one is not required to use all of them. Start with a medium 100 and work ones way up to the finer grit to get the shining wooden finish. Learn more by reading a few random orbital sander reviews.
Working in wood dust
One must avoid the wood dust created by this sander by attaching a vacuum to the orbital sander so that the dust is continuously sucked in. Since the dust keeps getting sucked, it cannot collect and form a layer between the sandpaper and the wood, thus the disc is constantly in contact with the wood. This will help in getting the work done quickly and increase the sander’s efficiency by giving a smooth result in less time.
If one is accustomed to working with sandpapers where fast movement is required, then they need to have control over their speed when working with random orbit sanders. This sander is designed to work best when it is used at a very slow pace, approximately an inch every second. The slow pace allows the proper working of the random oscillations of the disc which in turn leaves very few scratches and visible patterns.
Don’t forget hand sanding
The electronic sanders will not be able to give the perfect finishing, so one needs to finish by sanding by hand. This usually is required when working on hardwood, because the sander leaves subtle patterns which can be removed by using a fine-grit sanding block for sanding by hand.
The random orbit sander definitely makes sanding easier and gives a good result but since it is a powerful tool, one needs to use it carefully. The above-mentioned points are some of the basic mistakes that one should avoid while working with this tool.